Stormcure is an accelerator designed to be used with Stormsure® Flexible Repair Adhesive to significantly reduce curing time from 24 to 48 hours down to approximately 1 hour.

Mixing Ratio

Mix the accelerator at a ratio of 1:5.

• 1 part accelerator
• 5 parts adhesive

This equates to 1ml of accelerator mixed with 5ml (5g) of adhesive.

Coverage

A 30ml bottle of accelerator is sufficient to speed up curing for approximately:

• 2 × 90g tubes of Stormsure Flexible Repair Adhesive
• 10 × 15g tubes of Stormsure Flexible Repair Adhesive
• 30 × 5g tubes of Stormsure Flexible Repair Adhesive

Directions for Use

1. Squeeze the adhesive into a suitable container, plate, or tray.
2. Add the accelerator to the adhesive.
3. Mix thoroughly and quickly using a spatula or similar tool.
4. Apply the mixed adhesive directly onto the surface to be repaired.

You should notice the adhesive curing much faster than normal.

The accelerator can also be used to pre-clean surfaces and for cleaning up after repairs.

Supplied in a bottle with a tamper-proof lid.

Note: Any container, plate, or tray used for mixing will likely need to be discarded after use, so avoid using anything of value.